Design-to-Cost (DTC) in Plastic Part Design - Example housing for electronic device

Hello and welcome to a new post. In today's post we discuss the Design-to-Cost (DTC) approach in plastic part design.

Example housing for electronic device

A company is developing a new plastic housing for an electronic device. The target cost for the housing is €1.00 per unit, including material, manufacturing, and finishing.

Figure 1: 5 steps of a Design-to-cost approach in plastic part design.

Step 1: Set Cost Target

The project team establishes that the plastic housing must not exceed €1.00 per unit to remain competitive in the market.

Step 2: Analyze Cost Drivers

Material selection: Polycarbonate (PC) is initially considered, but its cost is relatively high.

Wall thickness: Thicker walls increase material usage and cycle time.

Part complexity: Complex geometries require more expensive tooling and longer molding cycles.

Surface finish: High-gloss or textured finishes may require additional processing.

Step 3: Generate Design Alternatives

Material: Evaluate switching from PC to a less expensive material, such as polypropylene (PP) or ABS, if performance requirements allow.

Wall thickness: Reduce wall thickness from 2.5 mm to 2.0 mm, maintaining structural integrity through ribbing and optimized geometry.

Geometry: Simplify the design by minimizing undercuts and eliminating unnecessary features, allowing the use of a simpler mold.

Surface finish: Specify a standard mold finish instead of a high-gloss or textured finish to reduce costs.

Step 4: Cost Estimation and Iteration

The team estimates the cost of each design alternative using supplier quotes and manufacturing simulations.

For example, switching to ABS and reducing wall thickness lowers material and cycle time costs, bringing the estimated cost to €0.95 per unit.

Step 5: Finalize Design

The design that meets both functional requirements and the cost target is selected.

The team documents the design choices and cost rationale for future reference.

Conclusions 

By applying the Design-to-Cost method, the team systematically reviewed material, geometry, and process options to ensure the plastic part meets its cost target without compromising essential performance.

Thanks for reading & #findoutaboutplastics!

Greetings, 

Herwig Juster

🔎I review your polymer material selection and plastic part design - contact me here

🔥 There is a problem keeping you awake - My personal website for Polymer Consulting

📊 Discover your Polymer Material Selection score by taking quick test here

Literature: 

[1] https://www.megatron.de/en/category/plastic-housing.html